SAFE OPERATION - 4 4. Observe all local traffic and safety regulations. Use the registration plate as required. (1) 3-point hitch lock button (1) Registration plate 11.If you drive the tractor with a trailer loaded with something heavy in tow and step on the brake pedal, the tractor is pushed forward by the trailer due to an abrupt slowdown. This may fail to keep the tractor under control. Before stepping on the brake pedal, press the transmission ratio lock button for smooth slowdown in combination with the engine brake. [Premium KVT model] 5. Turn the headlights on. Dim them when meeting another vehicle. 6. Drive at speeds that allow you to maintain control at all times. 7.
Do not apply the differential lock while traveling at road speeds. The tractor may run out of control. 8. Avoid sudden motions of the steering wheel as they can lead to a dangerous loss of stability. The risk is especially great when the tractor is traveling at road speeds. 9. Do not operate an implement while the tractor is on the road. Lock the 3-point hitch in the raised position. For travelling with the ride control on, however, keep the 3- point hitch unlocked. 10.Set the 3-point hitch lock button in the "LOCK" position to hold the implement in the raised position. 3. PARKING THE TRACTOR 1.
Disengage the PTO, lower all implements to the ground, place all control levers in their neutral positions, set the parking brake, stop the engine, remove the key from the ignition and lock the cab door (if equipped). Leaving transmission in gear with the engine stopped will not prevent tractor from rolling. 2. Make sure that the tractor has come to a complete stop before dismounting. 3. Avoid parking on steep slopes, if at all possible park on a firm and level surface; if not, park across a slope and chock the wheels. Failure to comply with this warning may allow the tractor to move and could cause injury or death. 4. OPERATING THE PTO 1.
Wait until all moving components have completely stopped before getting off the tractor, connecting, disconnecting, adjusting, cleaning, or servicing any PTO driven equipment.