Scania engines engine warranty for industrial engines Scania engines engine war- ranty for industrial engines in the engine manufacturer's application for certification. Emission control systems warranty Where a warrantable condition exists, Scania will repair your heavy-duty off-road engine at no cost to You including diagnosis, parts, and labor. IMPORTANT! Warranty period This warranty shall apply for one of the follow- ing periods, whichever occurs first: Only applicable to engines used in the U.S.A.
Table of Contents General warranty provisions 12 Warranty period 12 Parts covered by the Warranty 13 General warranty limitations 14 Specific warranty exclusions 15 Customer support 15 3,000 hours of operation as determined by a device to measure hours of use, or Five years Each engine is equipped with a device to meas- ure hours of use. If that device fails to account for hours of use due to defects in materials or work- manship, the engine shall be warranted for a pe- riod of five years. The warranty period shall begin on the date the engine is delivered to the first ultimate purchaser who, in good faith, pur- chases the engine for purposes other than immi- nent resale.
Emission control system war- ranty statement The Warranty on emission-related parts shall be interpreted as follows: General warranty provisions The emission control systems of your new Scan- ia Engines (“Scania”) industrial diesel engine were designed, built and tested using genuine parts, and were certified as being in conformity with federal emission control regulations. Scania warrants to the original owner, and to each sub- sequent owner, of a new Scania industrial diesel engine (“You”) that the engine: 1.
Any warranted part which is not scheduled for replacement as required maintenance in Scania's written instructions for maintenance and use of the engine by owner shall be war- ranted for the warranty period defined above. If any such part fails during the period of warranty coverage, it shall be repaired or re- placed by the engine manufacturer according to Subsection (4) below. Any such part re- paired or replaced under the Warranty shall be warranted for the remaining warranty pe- riod. 1. Was designed, built and equipped so as to conform at the time of sale with all applica- ble regulations under Section 213 of the Clean Air Act, 42 U.S.C.
§ 7547, for their full useful life and designed, built and equipped so as to conform with all applicable regulations adopted by the California Air Re- sources Board pursuant to its authority under Chapters 1 and 2, Part 5, Division 26 of the California Health and Safety Code, and; 2. Any warranted part which is scheduled only for regular inspection in Scania's written in- structions for maintenance and use of the en- gine by owner shall be warranted for the warranty period defined above. A statement in such written instructions to the effect of “repair or replace as necessary” shall not re- duce the period of warranty coverage.
Any such part repaired or replaced under warran- ty shall be warranted for the remaining war- ranty period. 2. Is free from defects in material and work- manship which would cause such engine to fail to conform to applicable regulations for its warranty period or otherwise cause the failure of a warranted part to be identical in all material respects to the part as described OPM 300 en-GB 12 © Scania CV AB 2015, Sweden