HOW-TO SECTION Oil analysis may be used to determine whether this interval should be shortened, but it should not be used to lengthen the interval. Filters should be used to maintain a clean system, not to clean up a contaminated system. Filter part numbers are listed in the Specifications section of this guide. The use of fuels with sulfur content above 0.05 mass percent will require a shortening of drain intervals and/or the use of a higher TBN oil. For detailed information refer to publication Engine Requirements – Lubricating Oil, Fuel and Filters (7SE270), available from authorized Detroit Diesel distributors.
Replace Spin-On Type Oil Filter Replace spin-on type filters (see Figure 22) as follows: Disposing of Waste Oil Dispose of used lubricating oil and filters in an environmentally responsible manner, according to federal (EPA) and/or state recommendations. The disposal of waste oil may be best addressed by the engine oil supplier, who may accept responsibility for proper disposal of this material as part of the business of providing lubricant. How to Replace the Lube Oil Filters Filters are an integral part of the lubricating oil system. Proper filter selection and maintenance are important to satisfactory engine performance and service life.
Figure 22 Spin-On Oil Filters 78 All information subject to change without notice. DDC-SVC-MAN-0039 Copyright © 2009 DETROIT DIESEL CORPORATION