4. MAINTENANCE 7. Lubrication (Track Loader) There are twenty two (22) grease fittings located on the track loader that require lubrication every eight hours. Lubricate with a good quality multi-purpose lithium based grease. Grease all hinge pin fittings and pivot bearings until excess shows. Add 2 shots of grease to support arm bearings.. (See Fig. 4.3F). The twenty two (22) lubrication points are: Rear Lift Arm Pivots (2) Lift Cylinder Bushings (4) Bucket Cylinder Bushings (4) Lift Arm Supports (2) Quick Tach Pivot and Lock Pins (4) Tandem Pivots (2) Support Arm Bearings (4) C4390 Fig. 4.3F 8. Engine Oil Level Check the oil before engine start up.
If the engine has been running let it cool for at least 5 minutes to allow the oil to drain back to the oil pan. To check the oil level, check with the loader on level ground, open the rear door and remove the dipstick (Fig. 4.3E). Keep the oil level between the full and low mark on the dipstick (Fig. 4.3F). Do not fill above the full mark. Use API Classification CF oil. Dipstick Location 9. Radiator / Oil Cooler Service C3783 Fig. 4.3E With the engine cool, check the coolant level in the overflow reservoir (Fig. 4.3G). Ensure the coolant level is at the Full-Cold mark on the reservoir by adding a 50% mixture of ethylene glycol and water if required.
FULL The radiator and oil cooler fins must be kept free of debris otherwise overheating of the engine and hydraulic system will occur. Inspect the radiator cooling fins for damage or buildup of debris. Repair any damage and if necessary clean the radiator with compressed air to remove debris. C3414 Fig. 4.3F LOW 42