Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-112 Tighten the capscrews, in the sequence shown. Torque Value: 47 [35 ft-lb] Injectors - Installation Do not stretch the o-rings as they are installed. The o-rings must be correctly installed in the grooves to prevent leaks. NOTE: It is important that the three injector o-rings be in- stalled in the correct orientation. Install the three new o-rings as follows: Part No. Location Color Code 3070136 Top Black or Red 3070137 Middle Brown or White 3070138 Bottom Black with White Dot or Light Blue Lubricate the o-rings with clean 15W-40 oil just before installation.
Place the injector in the cylinder head injector bore with the injector solenoid valve toward the intake port. Align the injector equally between the valve springs. Caution: Do not drive the injector in by striking the top stop or solenoid valve area. This can damage the sole- noid, or cause the injector to be out of alignment in the bore which will result in o-ring damage. Use injector tool, Part No. 3823579, to seat the injector in the bore. Install the hold down clamp and capscrew (M10-1.25 x 75). Tighten the capscrew. Torque Value: 75 [55 ft-lb]