Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-121 Turn the slave piston adjusting screw down until it touches the feeler gauge. Hold the adjusting screw in position and tighten the locknut. Without Adapter: Torque Value: 34 [25 ft-lb] With Adapter: Torque Value: 30 [22 ft-lb] Caution: After the slave piston adjusting screw locknut is tightened to the correct torque value, measure the clearance with a feeler gauge again. Do not tighten the adjusting screws too tight. The engine can be damaged. Adjust the appropriate injector and valves following the injector and valve adjustment sequence chart.
Repeat the process to adjust all injectors, valves and slave pistons correctly. Actuator Harness - Installation Install the internal actuator wiring harness on the engine. The harness and connectors must be clear of any moving parts so the wires will not be damaged during engine operation.