Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-123 Install new o-ring seals on the connector ends of the internal and external actuator harness where it passes through the rocker lever housing. Lubricate the connector with lubricant DS-ES, Part No. 3822934. Install the ends through the rear end of the rocker lever housing. Using a Torx W screwdriver (T-25), tighten the locking capscrew. The screw head is on the inside plug of the harness. Torque Value: 1 [11 in-lb] Install the oil temperature sensor (1) and the oil pressure sensor (2) to the cylinder block. Torque Value:
Temperature Sensor 34 [25 ft-lb] Pressure Sensor 30 [22 ft-lb] Install the engine position sensor (3) to the rear of the gear housing. Torque Value: 34 [25 ft-lb] Sensor Harness - Installation Install the sensor wire harness. Use wire clamps to fasten the coolant temperature sensor lead to the gear housing (1), and to the front of the rocker lever housing (2) and (3). Install a wire clamp around the sensor harness and act- uator fuel shutoff solenoid wire, and fasten the clamp to the cylinder block at point (1). Install another wire clamp around the intake temperature and boost pressure sensor wires and actuator harness, and fasten them to the camshaft rear cover plate (2).