Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-125 Rocker Lever Cover - Installation Install a new gasket on the cover. Install the cover on the rocker lever housing. Install the 16 isolators and capscrews (M8-1.25 x 40) in the cover. Torque Value: 15 [130 in-lb] Tighten the capscrews in the sequence shown. Install the breather hose and retaining clip. Hand Hole Cover (Fuel Pump Side of Engine) - Installation Use a new gasket and install the hand hole cover and the four capscrews (M10-1.50 x 20). Torque Value: 47 [35 ft-lb] Air Compressor Coolant Inlet Tube Fitting - Installation Loosen the locknut so there is space between the nut and o-ring.
Apply a thin coat of oil to the o-ring. Install the fitting into the cylinder block until the o-ring contacts the block. NOTE: The fitting must be installed with the threaded end at the 9:00 o’clock position. Tighten the locknut. Torque Value: 47 [35 ft-lb]