Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-136 Alternator Drive Seal - Installation The oil seal must be installed with the lip of the seal and the shaft clean and dry. The yellow dust lip of the seal must be facing out. Use the installation sleeve provided in the seal kit to install the new seal and gasket. Apply sealant, Part No. 3375066 or equivalent, to the threads of the capscrews. Install the clamping ring with five M8-1.25 x 20) capscrews. Tighten the capscrews in a star pattern in two steps. Torque Value: Step 1 - 7 [ 60 in-lb] 2 - 20 [180 in-lb] Place a light film of oil or anti-freeze on the inside diam- eter of the oil seal dust seal.
Install the dust seal onto the shaft with the larger outside diameter facing towards the engine. Push the dust seal back by hand on the shaft until the entire dust seal contacts the oil seal case. Alternator Drive Pulley - Installation Use pulley pusher adapter (1), Part No. 3377401, and pulley installation tool (2), Part No. 3376326, to install the pulley. Install the pulley retainer capscrew (M12-1.75 x 40). Torque Value: 75 [55 ft-lb] Lubricating Oil Filter Head - Installation Use a new gasket and install the filter head with six capscrews (M10-1.50 x 170) and three capscrews (M10- 1.50 x 30). Torque Value: 47 [35 ft-lb]