Section 14 - Engine Testing - Group 14 Engine Dynamometer - Install Engine (14-01) M11 Page 14-29 Starting Motor Inspect the voltage rating on the starting motor before installing the electrical wiring. Install the electrical wiring to the starting motor and bat- teries, if used. NOTE: If another method of starting the engine is used, follow the manufacturer’s instructions to make the neces- sary connections. Engine Throttle Control Engines which are run on an engine dynamometer re- quire that the sensor and actuator harness be installed, and connected to the engine. Additionally, a special en- gine dynamometer version of the OEM wiring harness and throttle control must be installed.
A special wiring harness and throttle control, Part No. 3823948, has been developed to enable engine operation out of chassis. Connect the dynamometer test OEM wiring harness amp connector to the ECM. Tighten the connector capscrews to the ECM. Torque Value: 2.0 [18 in-lb]