Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-65 Rotate the engine on the rebuild stand to position the cylinder head mounting surface facing up. Install two guide pins, Part No. 3376697, into the flywheel housing mounting holes of the cylinder block. Apply a 2 mm [1/16 inch] bead of sealant, Part No. 3823494, on the mounting surface of the housing and around each of the mounting capscrew holes. This component weighs 23 kg [50 lb] or more. To avoid personal injury, use a hoist or get assistance to lift the component. Install the REPTO flywheel housing over the guide pins.
Install the five of the seven long capscrews (M16-2.00 x 130) and the five short capscrews (M16-2.00 x 60). Remove the two guide pins and install the two remaining (M16-2.00 x 130) capscrews. Tighten the capscrews to the following value: Torque Value: 7 [60 in-lb] NOTE: This is not the final torque value. The flywheel hous- ing bore must be aligned with the crankshaft. The capscrews will be tightened to the final torque value after the flywheel housing is aligned.