Working hydraulics circuit II 257 X Press the 9 button on the steering wheel or the black button on the control lever until the indicator lamp in button V lights up. Front working hydraulics circuit II is activa- ted. The symbol for front working hydraul- ics circuit II symbol Z is coloured. Activating working hydraulics circuit II Switching front working hydraulics cir- cuit II back to standby mode X Call up the Hydraulics menu window ( Y page 237). X Using the r or s button, select front working hydraulics circuit II. Hydraulic system X Press the 9 button on the steering wheel or the black button on the control lever until the indicator lamp in button V flashes.
The symbol for front working hydraulics cir- cuit II Z has a coloured border. Front work- ing hydraulics circuit II is in standby mode. Deactivating front working hydraulics cir- cuit II X Press button V . The indicator lamp in button V goes out. or Switching side and rear working hydraul- ics circuit II to standby mode X Connect the equipment to the working hydraulics (see the manufacturer's sepa- rate operating instructions) ( Y page 230). X Switch off the hydraulic system ( Y page 230). or X Make sure that the hydraulic system is switched on ( Y page 230). X Start the engine. X Turn the key to position 1 in the ignition lock. X Press button W . The indicator lamp in button W flashes.
The Hydraulics input window opens in the on-board computer. Side and rear working hydraulics circuit II line \ is selected. Side and rear working hydraulics circuit II is in standby mode. Activating/deactivating side and rear working hydraulics system circuit II ! Only switch on the hydraulic system when it is connected to an item of attached equipment. There is otherwise a risk of damage to the hydraulic system. Selecting an operating mode X Attached equipment with constant flow rate: make sure that LS is not in the Z