TM2361 (24JUN08) 9015-15-23 450DLC Excavator Operation and Tests 062608 PN=467 Sub-System Diagnostics When the engine speed dial is at a speed setting The MCF will send a signal to the ECM to increase above auto-idle speed and the hydraulic functions are actual engine speed more than the target speed when not operated for more that 4 seconds, the MCF will the following conditions occur: send a signal to the ECM (through the CAN data link) to reduce the engine speed to the auto-idle speed.
If • Engine speed dial set to target speed of 1070 rpm the engine speed dial is set to a speed setting below or higher auto-idle speed, the engine speed will not increase or • Pressure sensed by travel right pressure sensor decrease after 4 seconds. (B56) and travel left pressure sensor (B57) Auto-idle is activated when the following conditions are Attachment Operation Speed Control: The attachment met: operation speed function provides an increased or decreased maximum engine speed setting when • Auto-idle switch is at the A/I position. operating in the attachment mode.
The attachment • No hydraulic functions activated for at least 4 operation speed setting can be adjusted (increased or seconds. decreased) using the Dr.ZX application. • Engine speed more than 1030 rpm. The MCF will send a signal to the ECM to increase or Auto-idle mode deactivates when any of the following decrease actual engine speed more or less than the conditions occur: target speed (as set by the engine speed dial) when the following conditions occur: • Auto-idle control switch turned to OFF. • A hydraulic function is actuated. • Power mode switch at HP position • Power mode switch is turned from E to P or P to E.
• Attachment mode selected for work mode setting • Engine speed dial is turned to change engine speed. • Engine speed dial set to fast idle position • Attachment operated [MCF detects pressure sensed When auto-idle is deactivated, the engine rpm by attachment pressure sensor (B45) at MCF increases to the setting of the engine speed dial. terminal D10] Travel Speed Increase Control: When in travel mode, Pump Control—The pump control involves the the MCF sends a signal to the ECM (through the CAN following functions: data link) to increase engine speed approximately 100 rpm more than the target speed (as set by the engine • Pump Flow Rate Control speed dial).
• Engine Speed Sensing Control • E Mode Control During travel operation, the MCF will also increase • Horsepower Control main relief pressure by energizing the power dig • Relief Flow Reducing Control solenoid. See Valve Control—Power Dig Solenoid • Swing Horsepower Reducing Control (Y24) (SG) later in this theory of operation. The MCF • Overheat Prevention Control also activates travel alarm (H4). For more information, • Fan Pump Flow Control see Travel Alarm Circuit Theory of Operation. (Group • Pump Learning Control 9015-15.) • Attachment Mode Control Continued on next page CS33148,00008EB –19–28APR06–6/15 9015 15 23