References Left Console Switch Remove and Install 1. Lift pilot control lever boot (1) and remove screws and spacers (2). 2. Remove cap screw (4). TX1005218A –UN–27MAR06 3. Lift left console (3) and disconnect harness to switch. 4. Repair or replace parts as necessary. 5. Install switch and connect harness. Left Console Switches 6. Install left console and cap screw. 1—Pilot Control Lever Boot 2—Screw and Spacer (4 used) 3—Left Console 4—Cap Screw 7. Install pilot control lever boot, screws, and spacers. LD30992,0000433 –19–23MAR06–1/1 TM2361 (24JUN08) 9015-20-117 450DLC Excavator Operation and Tests 062608 PN=607 Disconnect Tab Retainer Connectors IMPORTANT:
Do not disconnect electrical connectors while the engine is running. Damage to controllers or other components may result. Disconnect connectors only –UN–22MAY91 when instructed during a test or check. DO NOT pull on wires to disconnect connector or damage to wires or T7535AE connector may result. Grasp both halves of the connector to pull connector apart. A—Retainer Tab 1. Push retainer tab (A). 2. While holding tab in, grasp other half of connector and pull connector halves apart. 3. To connect, push connector halves together until retainer “clicks”. LD30992,000023B –19–31MAR06–1/1 9015 20 ,117