John Deere 450DLC — Bent Track Shoes Diagnostic Procedure

TM2361 (24JUN08) 9020-15-3 450DLC Excavator Operation and Tests 062608 PN=631 Diagnostic Information 1 Front Idler, Track Rollers, or Carrier Rollers Check Check for oil leakage caused by loose, worn or damaged plug, O-ring, or metal faced seal. Are plug, O-ring, and metal faced seal properly installed? YES: Diagnostic procedure complete. NO: Tighten plug. Replace O-ring or metal face seal. Replace seals. See Front Idler Remove and Install. (Group 0130.) Replace seals. See Track Roller Remove and Install. (Group 0130.) Replace seals. See Track Carrier Roller Remove and Install.

(Group 0130.) – – –1/1 Bent Track Shoes Diagnostic Procedure – – –1/1 9020 15 3 1 Track Shoe Check Inspect track shoes for missing or loose cap screws. See Check Track Shoe Hardware. (Operator’s Manual.) Are all track shoes cap screws in place and tight? YES: Go to Track Shoe Wear Check. NO: Remove loose track shoes to clean material from between shoe and link. Install track shoes and tighten cap screws in proper sequence. See Track Shoe Remove and Install. (Group 0130.) – – –1/1 2 Track Shoe Wear Check Measure grouser height and compare to specification for rebuilding or replacing track shoes. See Percent Worn Charts.

(SP326 Undercarriage Appraisal Manual.) Is grouser height above specification? YES: Go to Machine Operating Condition Check. NO: Repair or replace track shoes. See Track Shoe Remove and Install. (Group 0130.) – – –1/1