John Deere 450DLC — All Functions Cannot Be Operated Diagnostic Procedure

TM2361 (24JUN08) 9025-15-12 450DLC Excavator Operation and Tests 062608 PN=762 Diagnostic Information 2 Pilot Shutoff Relay Check See System Functional Schematic. (Group 9015-10.) Switch pilot shutoff relay K2 with other similar relay. Run engine with pilot shutoff lever in unlocked position and operate hydraulic functions. Do hydraulics operate? YES: Install new pilot shutoff relay K2 and return other one to correct position. NO: Replace pilot shutoff switch. – – –1/1 3 Security Switch Relay Check See System Functional Schematic. (Group 9015-10.) Switch security relay K5 with other similar relay.

Run engine with pilot shutoff lever in unlocked (forward) position and operate hydraulic functions. Do hydraulics operate? YES: Install new security shutoff relay K5 and return other one to correct position. NO: Go to Pilot Shutoff Solenoid Check. – – –1/1 4 Pilot Shutoff Solenoid Check See System Functional Schematic. (Group 9015-10.) Remove connector from pilot shutoff solenoid valve. Key on, test voltage on terminal #2 at the harness end connector. Does terminal #2 measure approximately 24 volts? YES: Go to Solenoid Continuity Check. NO: Failed fuse #4 or open circuit in harness between fusible link 75A and pilot shutoff solenoid valve.

– – –1/1 9025 15 12 5 Solenoid Continuity Check See System Functional Schematic. (Group 9015-10.) Remove connector from pilot shutoff solenoid valve. Check for continuity between terminals #1 and #2 of the solenoid valve harness connector. Is continuity measured? YES: Go to Wiring Connector Check. (Group 9025-15.) NO: Replace pilot shutoff solenoid valve. – – –1/1