John Deere 450DLC — Left Travel Does Not Move During Single Travel Operation Diagnostic Procedure

Diagnostic Information Left Travel Does Not Move During Single Travel Operation Diagnostic Procedure NOTE: Pressure oil from pump 1 is also routed to the arm and boom cylinders, so these functions can move at slightly slower speed during single operation. In level crowd operation, pressure oil is routed to the boom before the arm, so arm speed can become very slow. The following item can also cause this problem. The pump 2 flow rate is minimized due to a malfunction. This will cause the left travel motor and swing motors to be very slow. IMPORTANT: All of the below symptoms must occur at same time to use this diagnostic procedure. Single swing operation speed is slow.

Arm is slightly slow during arm level crowding operation. Precision control of hydraulic function cannot be performed. –1/1 TM2361 (24JUN08) 9025-15-38 450DLC Excavator Operation and Tests 062608 PN=788 1 DTC Check See Reading Diagnostic Trouble Codes With Monitor Display. (Group 9015-20.) See Reading Diagnostic Trouble Codes With Service ADVISORDiagnostic Application Do any DTC exist? YES: Diagnose and repair as required to clear displayed DTC. Diagnostic procedure complete. NO: Go to Swing Operation Check. – – –1/1 9025 15 38 2 Swing Operation Check Key on, use monitor service menu to display Swing / Attachment Control Pilot Pressure. See Monitor Service Menu Operation.

(Group 9015-16.) Perform Cycle Times Check. (Group 9005-10.) Check swing speed. Is swing speed normal? YES: Go to Pump 2 Pressure Check. NO: Check monitor and see if swing pilot pressure is at 0 while swing is in neutral. If pressure is above 0 in neutral, locate source of leakage in circuit. – – –1/1