John Deere 450DLC — Auto Lubrication Does Not Operate Diagnostic Procedure

TM2361 (24JUN08) 9025-15-62 450DLC Excavator Operation and Tests 062608 PN=812 Diagnostic Information 3 Lubrication Pump Status Check Check pump lubrication status on monitor when auto lubrication switch is on. Is Comp displayed? YES: Go to Proximity Switch Check. NO: Go to Relay Swap Check. – – –1/1 4 Harness Check See System Functional Schematic, Wiring Diagram, and Component Location Master Legend. (Group 9015-10.) Remove connector form switch and main controller. Check for continuity between open in harness between terminal #9 at switch end and terminal #83 at end. Is continuity measured? YES: Repair or replace auto lubrication switch. NO: Repair or replace harness.

– – –1/1 5 Relay Swap Check. See System Functional Schematic, Wiring Diagram, and Component Location Master Legend. (Group 9015-10.) Swap auto lubrication relay K11 with another similar relay. Does symptom go away? YES: Replace auto lubrication relay K11. NO: Go to Continuity Check. – – –1/1 6 Continuity Check See System Functional Schematic, Wiring Diagram, and Component Location Master Legend. (Group 9015-10.) Disconnect harness from auto lubrication relay and from main controller. Check for continuity between terminal #2 harness relay end connector and terminal #B24 of harness end connector at main controller. Is continuity measured? YES:

Replace fuse #30 or open circuit between fuse #30 and auto lubrication relay K11. NO: Open circuit in harness between K11 and , replace or repair as required. – – –1/1 9025 15 62 7 Proximity Switch Check Check if auto lubrication is counting SW while switch is on. Is on / off switched and is it alternately displayed on monitor? YES: Repair damaged pipes on front attachments. NO: Go to Grease Pump Check. – – –1/1