John Deere 450DLC — Auto Lubrication Does Not Stop Diagnostic Procedure

Auto Lubrication Does Not Stop Diagnostic Procedure –1/1 TM2361 (24JUN08) 9025-15-63 450DLC Excavator Operation and Tests 062608 PN=813 Diagnostic Information 8 Grease Pump Check Inspect grease pump. Is grease pump operating? YES: Check the following items in this order: No grease, refill grease cartridge. Repair damaged piping between pump and distribution valve. Replace distribution valve. NO: Go to Grease Pump Harness Check. – – –1/1 9 Grease Pump Harness Check See System Functional Schematic, Wiring Diagram, and Component Location Master Legend. (Group 9015-10.) Disconnect harness connector at pump and check voltage on terminal #2. Turn key and auto lubrication switch on.

Does harness terminal #2 measure 24 V? YES: Go to Proximity Switch Harness Check NO: Repair or replace open wire in harness between relay K11 and pump. – – –1/1 9025 15 63 10 Proximity Switch Harness Check See System Functional Schematic, Wiring Diagram, and Component Location Master Legend. (Group 9015-10.) Remove harness from proximity switch. Turn key and auto lubrication switch on. Measure voltage at switch end connector terminal #3. Does terminal # 3 measure 24 V? YES: Replace proximity switch or repair open circuit in harness between switch and ground. NO: Repair open circuit in harness between relay K11 and proximity switch. – – –1/1