. OPERATION TROUBLES AND ACTIONS Starting Engine with Booster Cables When starting the engine with a booster cable, do as follows: Connecting and Disconnecting Booster Cables WARNING 3 - 137 When connecting the cables, nev er contact the positive (+) and negative (-) terminals. When starting the engine with glasses. a booster cable, always wear safety Be careful not to let the normal machine and problem machine contact each other. This prevents sparks from generating near the battery which could ignite the hydrogen gas gi ven off by the battery. If hydrogen gas explodes, it could cause serious injury. Be careful not to make a mistak e when connecting a booster cable.
In the last connection (to the up caused, connect the cable to a per structure frame), a spark will be spot as far away from the battery as possible. (Avoid the work equipm ent, however, because it is not a good conductor) When removing the booster c able, exercise good care so that the ntact each other, or they contact the booster cable clips may not co chassis. NOTICE The starting system for this mac hine uses 24 V. For the normal machin e, also use a 24V b The size of the booster cable an d clip should be suitable for the battry size . The battry of the normal machin e must be the same capacity as that of the engine to be st Check the cables and clips for d amage or corrosion.
ips are firmly connected. Make sure that the cables and cl Check that the lock levers and p arking brake levers of both machine ar e in the LOCK posi Check that each lever is in the N EUTRAL position. Booster Cable Connection Keep the starting switch of th machine in the OFF position. e normal machine and problem Connect the booster cable as fo llows, in the order of the numbers marked in the diagram. 1. Connect one clip of boos terminal of the problem ma 2. Connect the other clip of b terminal of the normal mac 3. Connect one clip of boos terminal of the normal mac 4. Connect the other clip of b frame of the problem mach ter cable (A) to the positive (+) chine.
ooster cable (A) to the positive (+) hine. ter cable (B) to the negative (-) hine. ooster cable (B) to the revolving ine.