. MAINTENANCE MAINTENANCE PROCEDURE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING 4 - 51 The parts and oil ar e at high temperatu re immediately after the engine is stopped, and may cause s erious b urns. Wait f or the temperature to go down before starting the o peration. If there is still pres sure remaining insid e the case , the oil o r plug may fly out. Loosen the plug sl owly to release the p Prepare a handle 1. Set the TOP m perpendicular to the ground surface. 2. Remove plug (F ) using the handl e. When t he oil lev el reaches a point 10 mm (0.4 in) below the correct amount of oil has been ad ded. 3.
If the oil level i s too low, install e forward or in re plug (F), operate levers, and driv vers e to one turn. Then repeat Step 2 to c heck again. 4. If the oil level is low, add engine oil throug h plug h ole (F) unti the oil overflow s from plug hole ( 5. After checking, REMARK There are two plugs (F). Add oil throug h the one easier t o fill oil and through which no in ternal gears are t o be seen .