. ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT ATTACHMENT REMOVAL AND INSTALLATION oil filler cap (F) on top of the hydraulic tank to eliminate the internal pressure in the hydraulic circuit. 6 - 18 Attachment Removal he ground and stop the engine. 1. 2. 3. 1. Lower th e attachment to t he ground and s top the engi 2. Turn the starting switch to ON position and push down t he lock lever to FREE position. h work eq uipment control lever and the back and forth, left and right at full 3. Operate eac h attachm ent co to 3 ntrol pedal left and righ t at full stroke 2 hydrauli c circuit. Loosen slowly 5.
After ch ecking that the oil temperature is l ow, turn the rotor of the of t stop he ar valve m to t s installed to he OFF pos the inlet and outlet piping at the side ition. 6. Remove the h oses on the attachment side. Install the plugs to the two outlet s. used to prevent the attachment from incorrect Th e plu gs are correct operatio n caused by mixin g in of foreign m atter. After th e plugs are correctly i nstalled, stor e the attachme nt.