Caterpillar — C11, C13, C15 and C18 Industrial Engines

RENR5042-02 59 Troubleshooting Section Troubleshooting: System Response: Perform the following diagnostic procedure: “Injector Solenoid Circuit - Test” The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged. Results: Possible Performance Effect: OK STOP. Engine misfires i02214584 CID 0003 FMI 11 Injector Cylinder #3 fault Low power Troubleshooting: SMCS Code: 1290-038 Perform the following diagnostic procedure: “Injector Solenoid Circuit - Test” Conditions Which Generate This Code: Results: The Electronic Control Module (ECM) is attempting to operate the injector.

The ECM detects an open circuit or a short circuit in the circuit for the injector. OK STOP. i02257789 CID 0004 FMI 06 Injector Cylinder 4 short If the cause of the diagnostic code is a problem in the common wire, two cylinders will be affected because of the shared common wire for the injectors. System Response: SMCS Code: 1290-038 The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged. Conditions Which Generate This Code: The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects a short circuit in the circuit for the injector. The injector may not operate while the condition exists.

System Response: Possible Performance Effect: The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged. Engine misfires Low power Possible Performance Effect: Perform the following diagnostic procedure: “Injector Solenoid Circuit - Test” Engine misfires Results: Low power OK STOP. Troubleshooting: i02257781 CID 0004 FMI 05 Injector Cylinder 4 open circuit Perform the following diagnostic procedure: “Injector Solenoid Circuit - Test” Results: SMCS Code: 1290-038 OK STOP. Conditions Which Generate This Code: The Electronic Control Module (ECM) is attempting to operate the injector.

The ECM detects an open circuit in the circuit for the injector.