24. SERVICE PROCEDURE The rubber of the rubber pin lock is torn, and the steel balls may come out. The steel balls can be buried when pressed with finger 4. Clean the surface of adapter and remove the soil from it with a knife. 5. Use your hand or a hammer to push rubber pin lock into the hole of the adapter. When doing this be careful that the rubber pin lock does not fly out from the adapter surface. 6. Clean the inside of point , then install it to adapter . If there is mud stuck to it or if there are protrusions, the point will not enter the adapter properly, and there will not be proper contact at the mating portion. 7.
Fit point to adapter , and confirm that when the pointer is pressed strongly, the rear face of the hole for the pin of the point is at the same level as the rear face of the hole for the pin of the adapter PC130/150LGP-6K ENG 3-36