24. SERVICE PROCEDURE 24.2.8 REPLACE BUCKET TEETH (HORIZONTAL PIN TYPE) Replace the teeth before the wear reaches the adapter. PC130/150LGP-6K ENG 3-38 WARNING It is dangerous if the work equipment moves by mistake when the teeth are being replaced. Set the work equipment in a stable condition, then stop the engine and apply the locks securely to the levers. WARNING 1. Set a block at the bottom face of the bucket so that it is possible to knock out the pin of tooth , then check that the work equipment is in a stable conditon, and lock the safety lock lever. Set so that the bottom face of the bucket is horizontal. 2.
Place a bar on the pin head and strike the bar with a hammer to knock out pin . Remove tooth . REMARK Use a round bar with a smaller diameter than that of the pin. 3. Clean the mounting face. Fit a new tooth in the adapter, push in pin partially by hand, then knock it with a hammer to install the tooth to the bucket.