OPTIONS, ATTACHMENTS 6. RADIO BAND SELECTOR (BAND) Radio operation: Press this button to change the radio band (FM1, FM2, AM, Weather Band). Cassette operation: Press this button to change manually from side one to side two of a cassette being played. 7 and 8. UP-DOWN TUNING/SEEK TUNING/CASSETTE FAST FOR- WARD AND REWIND To manually select a radio station, momentarily press the “UP” tuning button (7) to advance the tuning and display one digit higher, or the “DN” tuning button to tune one digit lower. Continue tapping to change to the desired station.
To automatically “seek” the station nearest to the one you are receiving, press the UP tuning button (7) to seek upward and hold until a “beep” is heard. Release the button and the radio tuning will stop and the next higher broadcasting station. Perform the same operation using DN button (8) to seek downward. During cassette operation, the UP and DN buttons actuate the fast-forward and rewind functions, respectively, regardless of which side of the cassette is being played. Press and release to start rewind or fast-forward; press again to halt the function. 9. RADIO-TIME/RADIO-TAPE SELECTOR (R/T) This displays the frequency, time, and operation modes.
If a cassette is in the player, this button functions as a radio/tape selector. Operation (tape playing): Tap the R/T button to pause the cassette and operate the radio; tap the R/T button again to display the frequency for five seconds; press until a “beep” is heard and then release to resume cassette play. Operation (radio playing): Normally the time is displayed, until the radio tuning is changed or button (9) is pressed. Then the radio frequency being received is displayed for five seconds. NOTE: If a cassette is in the player, a small cassette symbol appears on the LCD display. Leaving cassettes in the player for extended periods (overnight) can cause damage. 10.
RADIO STATION PRE-SET MEMORIES To set any of the five pre-set memories in each band: A. Turn on the system and select the band. B. Select the first station to be pre-set with the UP and DN tuning controls (7) and (8). C. Press the desired pre-set button (1 through 5) and hold until a “beep” is heard. D. Release the button. The display will show “CH1", “CH2" etc., depending on which buton was set. Now simply press the desired pre-set button to tune to the station in memory. 5-13 WA320-3MC