3B1-20 POWER STEERING 4. Y-Gasket Using needle, scriber or equivalent. 5. Sector Shaft Assembly Unless otherwise a problem, it is not necessary to disassembly. 6. Retainer 1) Raise the two lips of the retainer. Retighten to a torque of 39 N (4 kg /44 lb) and back off 20 degrees. Check that the adjuster screw turns smoothly. N3A0148E Caulk the retainer in position. 2) Using retaining bar. N3A0147E N3A0147E 3. Sector Shaft Assembly 4. Y-Gasket Install the gasket so that its lip faces to the bearing. If the lip is deformed, correct. Apply grease to Y-gasket. 5. Back Up Ring When the back up ring is installed, use installer for alignment. N3A0148E 7.
Adjuster Screw Inspection and Repair Refer to “Power Steering Unit” in this section. Reassembly 1. Adjuster Screw 2. Retainer Discard used retainer and install a new one. Install and fully tighten the retainer and back off 180 degrees.