28 GETTING TO KNOW YOUR VEHICLE The heated steering wheel control button is located on the center stack below the radio screen, or within the Uconnect system. DRIVER MEMORY SETTINGS — IF EQUIPPED This feature allows the driver to save up to two different memory profiles for easy recall through a memory switch. Each memory profile saves desired position settings for the following features: Push the heated steering wheel button once to turn the heating element on. Push the heated steering wheel button a second time to turn the heating element off. Driver seat NOTE: The engine must be running for the heated steering wheel to operate.
For information on use with the Remote Start system, see Ъ page 20. Easy Entry/Exit seat operation (on/off) (if equipped) Side mirrors Power tilt and telescopic steering column (if equipped) Memory Setting Buttons P ROGRAMMING T HE M EMORY F EATURE WARNING! A set of desired radio station presets NOTE: To create a new memory profile, perform the following: Persons who are unable to feel pain to the skin because of advanced age, chronic illness, diabetes, spinal cord injury, medication, alcohol use, exhaustion, or other physical conditions must exercise care when using the steering wheel heater. It may cause burns even at low temperatures, especially if used for long periods.
Your vehicle is equipped with two key fobs, each can be linked to either memory position 1 or 2. NOTE: Saving a new memory profile will erase the selected profile from memory. 1. Place the vehicle’s ignition in the ON/RUN position (do not start the engine). Be sure to program the radio presets prior to programming the memory settings. The memory setting switch is located on the driver’s door trim panel. The switch consists of three buttons: 2. Adjust all memory profile settings to desired preferences (i.e., seat, side mirror, power tilt and telescopic steering column [if equipped], and radio station presets).
Do not place anything on the steering wheel that insulates against heat, such as a blanket or steering wheel covers of any type and mate- rial. This may cause the steering wheel heater to overheat. The set (S) button, which is used to activate the memory save function. The (1) and (2) buttons which are used to recall either of two saved memory profiles.