Supermicro A+ Server 2021TM-BTRF/BIBXRF — Supermicro A+ Server 2021TM-BTRF/BIBXRF User Manual PDF

A+ SERVER 2021TM-BTRF/BIBXRF User's Manual Removing the Heatsink Warning: We do not recommend removing the CPU or the heatsink. If you do need to remove the heatsink, please follow the instructions below to prevent damage to the CPU or other components. ! Removing a Passive Heatsink Unplug the power cord from the power supply. 1. Disconnect the heatsink fan wires from the CPU fan header. 2. Use your fi ngertips to gently press on the fastener cap. Then turn it 3. counterclockwise for a 1/4 (90 0 ) turn and then pull the fastener upward to loosen it. Repeat Step 3 to loosen all fasteners from the mounting holes. 4. With all fasteners loosened, remove the heatsink from the CPU. 5.

5-6 Installing Memory ! CAUTION! Exercise extreme care when installing or removing DIMM modules to prevent any possible damage. Memory Support The H8DMT-F/H8DMT-IBXF supports up to 64 GB of DDR2-800/667/533 registered ECC SDRAM. Two-way interleaved memory is supported. (Populating DIMM1A and DIMM1B and/or DIMM2A and DIMM2B with memory modules of the same size and type will result in two-way interleaved memory, which is faster than single channel, non-interleaved memory.) Note that when ECC memory is used, it may take 25-40 seconds for the VGA to display.) Installing Memory Modules Insert each DDR2 memory module vertically into its slot, starting with DIMM 1. #1A.

Pay attention to the notch along the bottom of the module to prevent inserting the module incorrectly. Gently press down on the DIMM module until it snaps into place in the slot. 2. Repeat for all modules. (See support information below.) To enhance memory performance, install pairs of memory modules of the 3. same type and of the same bank (DIMM1A and DIMM1B) and then the next bank (DIMM2A and DIMM2B). 5-8