cisco — Configuring CoA on the Device

Configuring CoA on the Device Follow these steps to configure CoA on a device. This procedure is required. Procedure Configuring RADIUS Configuring CoA on the Device Command or Action Purpose Step 3 aaa group server radius group name _ Example: Device(config)# aaa group server radius abc Defines the RADIUS server group configuration and enters RADIUS server group configuration mode. Step 4 server name name Example: Device(config-sg-radius)# server name serv1 Associates the RADIUS server to the server group. Step 5 {ip | ipv6} radius source-interface type number Example:

Device(config-sg-radius)# ipv6 radius source-interface ethernet 0/0 Specifies an interface to use for the source address in RADIUS server. Step 6 dscp {acct dscp acct value|auth _ _ dscp auth value} _ _ Example: Device(config-sg-radius)# dscp auth 10 acct 20 Configures DSCP marking for authentication and accounting on the radius server group. • acct configures radius DSCP marking value for accounting. The valid range is from 1 to 63. The default value is 0. • auth configures radius DSCP marking value for authentication. The valid range is from 1 to 63. The default value is 0. Step 7 end Example: Device(config-radius-server)# end Exits RADIUS server mode and enters privileged EXEC mode.

Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password, if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Configuring RADIUS 36