Configuring RADIUS Source-Interface Under a RADIUS Server-Group The RADIUS source-interface can be configured under a RADIUS server-group in either of the following methods: • Configure a RADIUS source-interface under the RADIUS server-group using the ip radius source-interface interface-name command. • Configure a VRF using the vrf vrf-name command under the RADIUS server-group, and then associate the configured VRF globally to a source-interface using the ip radius source interface interface-name vrf vrf-name command. Priority will be given to the source-interface under the server-group configuration in case both methods are configured.
Either public servers or private servers can be configured under a server-group. We recommend that you configure public servers as described in the Defining AAA Server Groups, on page 29 procedure. To configure RADIUS source-interface under a RADIUS server-group, perform the following: Before you begin You must configure a VRF routing table and associate VRF to an interface Procedure Configuring RADIUS Configuring RADIUS Source-Interface Under a RADIUS Server-Group Command or Action Purpose Step 12 authentication command disable-port ignore Example:
Device(config)# authentication command disable-port ignore (Optional) Configures the device to ignore a nonstandard command requesting that the port hosting a session be administratively shut down. Shutting down the port results in termination of the session. Use standard CLI or SNMP commands to re-enable the port. Step 13 end Example: Device(config)# end Exits global configuration mode an returns to privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Configuring RADIUS 38