Chapter3 Handling Label Paper Settings • When using die-cut labels, use kiss cut die-cut label paper that has waste parts around each label. However, there should be no waste parts at both side edges of roll paper. • The Windows printer driver and PrinterSetting perform the following input value checks and automatic corrections. • The input value check checks that ("Left and Right Gap" x 2) + "Width" does not exceed the width of the paper. If the value being entered causes the maximum (minimum) paper width to be exceeded, the upper (lower) limit of the input value is limited and adjusted so that the maximum (minimum) paper width is not exceeded.
• Since input value checks and automatic correction are not performed except for the Windows printer driver and PrinterSetting, if paper layout settings such as left-right gap and label width are set from other software and the settings exceed the printing range, only the printable range will be printed. 291