5.3 Rapid reading of alarms The last three alarms can even be displayed if the selector is not in the tenth diagnostic position or if the appliance is in normal operating mode (for example when performing a wash programme): Press the START/PAUSE button and the nearest option button simultaneously (as if you were entering DIAGNOSTIC mode) for at least 2 seconds: the LCD display shows the last alarm. The alarm is displayed until another key is pressed. While the alarm is being displayed, the appliance continues to perform the cycle or, if in the programme selection phase, it maintains the previously selected options in memory.
5.4 Deleting the last alarm It is good practice to cancel the alarms stored: after reading the alarm codes, to check whether the alarm re-occurs during the diagnostic cycle after repairing the appliance, to check whether it re-occurs during testing N.B. With this operation all the alarms stored are deleted. A.D.L. 10 / 2010 13/26 599 73 54-08 Series 7 Series 8 1. Enter the diagnostic mode, 2. Turn the selector dial clockwise until the eleventh LED is turned on (in the left-hand alarm reading row) 3. Press the START/PAUSE button and the nearest option button simultaneously (as shown in the figure). 4. Hold down the buttons until the LCD display shows “E00” (at least 5 seconds).