User Manual of EM730/EM730E Series Inverter 155 1 1 Multi-segment PID setting 3 (F09.34) 17 Multi-segment torque terminal 1 The 4-segment torque setting can be performed via these two terminals, as detailed in the following table (0/1: the current function terminal is invalid/valid).
18 17 Multi-segment torque setting 0 0 Depending on the torque setting source option (F13.01) 0 1 Multi-segment torque 1 (F13.03) 1 0 Multi-segment torque 2 (F13.04) 1 1 Multi-segment torque 3 (F13.05) 18 1 7 Multi-segment torque setting 18 Multi-segment torque terminal 2 0 0 Depending on the torque setting source option (F13.01) 0 1 Multi-segment torque 1 (F13.03) 1 0 Multi-segment torque 2 (F13.04) 1 1 Multi-segment torque 3 (F13.05) 19 Acceleration and deceleration time terminal 1 The inverters of this series have four groups of acceleration and deceleration time in total. You can define two function input terminals as acceleration and deceleration time terminals.
The current acceleration/deceleration time of the inverter depends on the code combination of these four terminals and settings of related function codes. Details are given in the following table. (0/1: the current function terminal is invalid/valid); or see the function codes F15.03 to F15.13 for details. 20 Acceleration and deceleration time terminal 2 20 19 Acceleration and deceleration time 0 0 The first group (acceleration time: F00.14; deceleration time: F00.15) 0 1 The second group (acceleration time: F15.03; deceleration time: F15.04) 1 0 The third group (acceleration time: F15.05; Deceleration time: F15.06) 1 1 The fourth group (acceleration time: F15.07; Deceleration time:
F15.08) 21 Acceleration and deceleration prohibition When the acceleration and deceleration prohibition terminal is valid, the execution of acceleration and deceleration commands will be prohibited, and the output frequency of the inverter will remain unchanged. The inverter in the overcurrent protection status will run based on the current limit. 22 Operation pause The inverter decelerates to stop, but all running parameters will be kept in the memory, such as PLC and PID parameters. When this terminal is invalid, the inverter will restore the running status before stop.
23 External protection input Using this terminal, you can input the protection signal of the external device, to facilitate protection monitoring and protection of the external device via the inverter. Upon receiving an external protection signal, the inverter will display