Tutorial You’re going to be putting the samples you create into one of the kit sounds, so let’s select one that we’re not already using in our sequence. 2. Turn the Sound Type knob to select the DRUM-KIT SoundFinder category, and turn the Sound Name knob to select Dance Kit. 3. Hold down the Record button, press the Stop button, and then release both buttons to make sure that we’re at the beginning of our sequence. 4. Locate and press the Resampling Setup button. Setup Send To Pad(s) Start Stop Scratch Pad™ 5. Turn the Parameter knob until the display shows: Meter: Trig= є This is where you can set a level that determines how loud audio has to be to cause the ASR-X to begin sampling.
This is referred to as the trigger threshol d. 6. Turn the Value knob counter-clockwise to move the level indicator as far leftward as it will go. The farther to the left the indicator is set, the quieter the audio that will cause sampling to begin. 7. Turn the knob the other way to move the indicator to the right by one position. 8. Locate the Resampling Start/Stop button. Setup Send To Pad(s) Start Stop Scratch Pad™ 9. Press the Resampling Start/Stop button once. The display shows “Waiting for trigger” on its top line, since the ASR-X is waiting to hear some audio before it starts sampling. 10. Press the Transport Play button to play the sequence.
On the display, you’ll see “Sampling In Progress” to show that you’re now sampling. 11. When the sequence ends, press the Sample Start/Stop button again to stop sampling. ENSONIQ ASR-X User’s Guide 13 Resampling Resampling