sensor gasket has no obvious damage and penetrating indentation, and that the sensor and its mounting hole threads have no obvious deformation or damage, and then tighten it in accordance with the specified torque after uniformly applying an appropriate amount of thread sealant on the sensor threads. 2 Connect the harness connector A of the air conditioning coolant temperature sensor (cylinder head). 3 Install the air filter intake pipe assembly. 4 Install the air filter assembly. 5 Install the engine trim cover assembly. 6 Connect the negative cable of battery. 7 Use the GLDS diagnostic program.
On the [Software] tab, select the corresponding module and follow the steps prompted by the diagnostic program to complete the software flash operation. 8 Close the engine compartment cover. 2.2.6.13 Replacement of Air Conditioning Coolant Temperature Sensor (Cylinder Block) Removal Procedure Warning ！ Refer to "Warnings regarding battery disconnection" in " Warnings and Precautions ". 1 Open the engine compartment hood. KX11 PHEV 2023 2-46 Engine control system (DHE15-ESZ) Engine 2 Disconnect the negative cable of battery, refer to Procedures for disconnecting and connecting battery cable . 3 Remove the engine trim cover assembly, see Replacement of Engine Trim Cover Assembly .
4 Remove the air filter assembly, see Replacement of Air Filter Assembly . 5 Remove the air filter intake pipe assembly. refer to Replacement of air filter intake pipe assembly . 6 Disconnect the harness connector A of the air conditioning coolant temperature sensor (cylinder block), and remove the air conditioning coolant temperature sensor (cylinder block).