Chapter 3 Advanced Tool Tutorials 18. Minimize the Step Tree Editor. 19. Click . 20. Highlight Snapshot and click . This will place a green check mark next to Snapshot. 21. Highlight TwoPt Locator and click . 22. To set up the TwoPt Locator, enlarge the search areas Find Pin 1 (left boxes) and Find Pin 2 (right boxes) so that the tips of the prongs will always fall into them respectively for all images. The outer box of each Find Pin is its search area; the inner box is the template pin. Click on the Template Find Pin 1 box and place its center at the tip of the left prong. Place the center of the Pin2 template at the tip of the right prong.
Your setup for Two Pt Locator should appear as shown in Figure 3–22. FIGURE 3–22. Find Pin Setup Two Pt Locator and the Train button will display a red box until you have trained the tool. Also, the boxes around the untrained tool will remain dotted lines until trained. 3-32 Getting Started with Visionscape GigE Cameras