8. Once the tubes system has been purged, the following message will instruct you to open the Window: 9. Open the right cover and make sure the Maintenance Cartridge is installed in the Service Station. 10. When the following message appears on the Front Panel, open the Carriage cover and check the window on top of each Setup Printhead. If the Ink Supply Tubes have been primed correctly, the windows will contain ink. If the windows on top of each Setup Printhead does NOT contain ink, then you may need to repeat the Prime Tubes process from the beginning. 11. Remove ALL the Setup Printheads from the Carriage and install the previously removed Printheads. 12.
Once ALL the Printheads are installed, the Front Panel will instruct you to close the Carriage cover and close the Window. Tests and Utilities 13. The Printer will now perform the Printhead Alignment and the following message will be displayed on the Front Panel. To continue with the Printhead Alignment, use the select “Align now” and press the Enter key. Service Utilities 137