Separating the engine module from the paper-feed module 1 To separate the engine module from the paper-feed module: a Remove the tray 2 dust cover or the duplexer (if installed). a Remove the rear right side cover (page 138). b Remove the formatter assembly (page 151). c Remove the two long screws from the tray 1 pickup assembly (page 161 and 162). 2 2 1 Figure 78. Unplugging the connector to the paper-feed module 2 Unplug the connector (callout 1) to the paper-feed module on the right rear side of the printer (under the formatter assembly). Remove the cable from its brackets. 3 Remove the two screws (callout 2), or one screw, if the printer drive assembly has been removed.
EN Chapter 6 Removing and replacing parts 171