Removal and Installation 6. First remove lateral Pinch-Wheels with their Coupling Plates. NOTE For Pinch-Wheel groups installed around the Mount Brackets do the following: 7. From the front of the Printer, remove the Coupling Plate corresponding to the position of the Mount Bracket. REMOVE COUPLING PLATES 3 Mount Brackets in the 60" Model. 1 Mount Bracket in the 42" Model. 8. From the rear of the Printer, rotate the group (90 degrees) and pull it through the gap left by the Coupling Plate. 1 ROTATE 90 0 2 Installation of Pinch-Wheels NOTE During installation, make sure you install the White Pinch- Wheels at each end of the Printer axis.
8-99 HP DesignJet 5000 and 5500 Series Printers Service Manual