Delta ISPSoft — 23.2.2 Opening the Data Tracer Window

ISPSoft User Manual  Direction: Users can select CW clockwise motion or CCW counter clockwise motion.  Completion action: Go to next segment to complete the data and continue to the next. Completion refers to an end once data is complete.  Completion flag (I/M) : When the data execution is complete, set the register to ON. The register range is set as M0~M8191 or I510~I519 only when Completion action is set to Completion .  No. of next segment: Continue with the next data number, not limited to the same assigned axis number. But, take note that the same axis number cannot output more than 2 numbers from the table or output position command at the same time.

When Completion action is set to Completion , the number is automatically continued to the next segment Notice for table input: 1. The PLC automatically calculates the output speed in this function. The objective position cannot be set to 0 in the relative mode. The objective positions of two adjacent row numbers cannot be set to the same value in the absolute mode. 2. I number can be used more than once. Users must determine through which row number the I number can be completely outputted. 3. The instruction which the start table outputs is API2718 TPO. API2721 TPWL can be used to modify the output parameters while PLC is running.

23.2 Data Tracer 23.2.1 About Data Tracer Data Tracer is used once a triggering condition is reached to collect real-time symbol variables or status and using waveform graphs to analyze the value trends. 23.2.2 Opening the Data Tracer Window Please compile the current project before using the function. Click Wizard > Data Tracer on the tool bar to open the Data Tracer setup window as the image shown below. 23-14