ISPSoft User Manual 3.4.2.4 Option- Ethernet Setting (advanced) On the Ethernet Port Advance Setting window, users can set the parameters for sockets through which data is transmitted. In the Socket table, users can set COM port parameters for data transmission via Ethernet. However, the function should be applied with specific API instructions. Please refer to AHxxEMC Series Instrunction Manuals for more information. Sockets will not be introduced here. Please refer to related documents or manuals for more information about sockets.
The system for AHXXEMC series modules supports the data transmission between the CPU module and other CPU module or device via a socket as well as TCP and UDP protocols in each of which 8 groups of connections can be set. Users should select Socket Function Enable checkbox before any setup and then do other setting in TCP and UDP setting pages respectively. that there is no Keep Alive Timer parameter in the UDP Socket Setting. The parameters in the TCP and UDP The parameters in the TCP Socket Setting are the same as the parameters in the UDP Socket Setting except Socket Setting are described below. Remote IP : Users can set a remote IP address. Remote Port :
Users can set a communication port used by the remote device for this TCP connection. The port number must be within the range between 0 and 65535. Local Port : Users can set a communication port used by the local CPU module for this connection. The port number must be within the range between 0 and 65535. Send Address : Users can set the length of data which will be sent by the local CPU module. Send Length : Uses can set an initial device in the CPU module where data which will be sent is stored. The length must be within the range between 0 and 1000 bytes. 3-204