ISPSoft User Manual 3.7.2 Parameter Settings for AHxxEMC Modules Users can set the parameters in every module configured in HWCONFIG. The functions and characters of every module depend on the setting of the parameters. If users want to set the parameters in a module, they can double-click the module in the system configuration area. The system will automatically open the Parameter Setting window. The setting windows of various models are a bit different. AHxxEMC Series The parameters are set according to the functions supported by the module. Before users set the parameters, they have to refer to Operation Manual for more information.
To prevent damage to the system or staff, the users have to make sure of the effect that the parameters which are set have on the module and the whole system. There are two tabs in the setting window of AHxxEMC series modules. They are the Device Information tab and the Normal Exchange Area tab. If users click the Device Information tab, the module information, appearance and present DDF document version will be displayed. The number of parameters which can be set in the module and the range of setting values depend on the version of the DDF document. Besides, the firmware version and hardware version of the CPU module will be displayed as well when all modules are connected online.
If users click the Normal Exchange Area tab, the functions to which the input/output devices assigned to the module correspond will be displayed. Users can select a parameter type at the left side of the window, and then set the parameters in the table at the right side of the window. The formats of the tables for the parameter types are the same, but the contents of the tables are different. Besides, the number of parameters which can be set and the range of setting values 3-236