ISPSoft User Manual 2.4.6 Creating Connection Channel - Simulator with Operating Panels When the state of a simulator shows START, an operating panel (see below) pops-up to demonstrate the current states of AH5x0 and AH5x1 simulators and provide STOP or RUN mode for users to control. The IO Module button of a simulator can open an IO module panel. However, modules must be configured in HWCONFIG and please refer to section 3.8.4 for parameter download to hosts. Users can switch to RUN mode and view the same HWCONFIG module configuration and state on IO module panel. The following chart demonstrates the digital input and output registers area.
The Y device offers only output status but cannot perform any operation; while X device offers users to click and change the ON/OFF status of each contact for external input simulation. 2-54