L-4733A/L-4733AW Operation Guide Overview of the Product 28 Press Main Unit and Touch Panel Temperature and humidity Recommended environment when printing: Temperature: 20 to 26˚C Humidity: RH 35 to 55% without condensation Recommended environment when stopped (at night and so on): Temperature: -10 to 40˚C Humidity: RH 30 to 55% without condensation Use the press in an air-conditioned environment in which you can accurately control the temperature and relative humidity. At altitude Less than 2000 m above sea level Noise While printing: 75 dB (A) Waste heat duct We recommend installing a waste heat duct near the exhaust vent at the rear of the main unit.
Recommended specifications Distance from the unit: 150 mm (-0 mm, +10 mm) It cannot be connected directly to the main unit When the waste heat duct is installed, change the direction for the intake and exhaust air direction box on the rear of the unit. Inflow rate: 9.5 m3/min The whole unit generates 6 kW of heat. By using a waste heat duct, you can reduce the amount of heat generated by approximately two thirds thereby saving on air conditioning. Taking into account the heat generation mentioned above, use the press in an air-conditioned environment in which you can accurately maintain the temperature and relative humidity.
Sensor for Transparent Substrate Detection method Ultrasonic waveform Substrate Specifications Face: transparent or semi-transparent Separator: transparent or semi-transparent Unavailable functions Re-registration printing (However, this function is available when using substrate with a white band printed underneath the registration marks.) Auto measuring substrate width (Use the key pad to enter the substrate width when you replace the substrate.) Rewinder (Optional item) External dimensions Length: 1310mm Width: 900 mm Height: 1000 mm U “External dimensions and necessary space” on page 34 Necessary space U “External dimensions and necessary space” on page 34 Mass Approx. 180 kg