L-6534VW Operation Guide Basic Operations This completes this section. A From the menu on the left of the touch panel, press Substrate Settings and then Change Substrate . c Important: In the following situations, do not press Change Substrate . ❏ When splicing a new substrate of the same type without changing the paper core during a print job. When using one roll substrate, an error may occur in the rotation speed of the drum if any tension settings are changed during operation. If Change Substrate is pressed, replace the rewinder side substrate with a new paper core.
❏ When a roll end error occurs during a print job When replacing with the same substrate from the Change Substrate screen, the print position may shift. Also, do not move the paper edge sensor. U “The print position shifts when replacing with the same type of substrate during a print job” on page 403 100 Press Match the paper edge sensor to the width of the substrate. Press Return the adjustment volume on the ionizer to 0. Touch panel On the Change Substrate screen, perform settings for the replaced substrate. Touch panel Press Start to feed the splice toward the rewinder axis.