L-6534VW Operation Guide Overview of the Product Control panel Located on three locations in the front section of the main unit. Sub panel Main panel Panel on the rewinder side workbench 27 Letter Name Explanation b Eye mark sensor Sensor to detect the eye mark on the substrate. Aligns for printing when performing reverse feeding of the substrate or performing additional printing. c Paper edge sensor Sensor to detect the edge of the substrate. Based on the position of the edge of the substrate measured with this sensor, the position of substrate is controlled. d Joint sensor Sensor to detect a splicing tape over splices (joints) in the substrate.
Upon detecting any splice, the operation preset on the touch panel will be done. e Roll diameter sensor Sensor to detect the roll diameter of the substrate. The roll diameter sensor is located on the unwinder side and the rewinder side. Based on the value of Paper Core Thickness entered when replacing the substrate, printing stops when little substrate remains. In addition, based on the detected results of the roll diameter, the tension on the substrate on the unwinder and the rewinder sides is controlled. Letter Name Explanation a EMERGENCY STOP switch Push to immediately stop the press. The corona treater and the additional UV lamp curing unit also have an EMERGENCY STOP switch.
b Feed Ready switch Turns the tension for the entire substrate feeder ON/OFF. c Rev. Feed switch Winds up the substrate while pushed down. d Slow Rev. Feed switch Slowly winds up the substrate while pushed down. The Slow Rev. Feed switch is also located on the rewinder side workbench. This is useful for adjusting the position of the substrate on the rewinder side workbench.