L-6534VW Operation Guide Overview of the Product 53 Item Explanation Eye Mark Horizontal Offset Set the distance between the right edge of the eye marks and the right edge of the print data as an offset of the horizontal direction when performing additional printing. Set the correction value within a range of -1,000.00 to 500.00 mm (-39.370 to 19.685 inch). You can switch the units between inch and mm. Disabled when Additional Printing is set to Do Not Apply. Default: 0.00 mm (0.000 inch) Eye Mark Pitch Set the eye mark gap. Set the Eye Mark Pitch within a range of 30.00 to 1,000.00 mm (1.181 to 39.370 inch). You can switch the units between inch and mm.
Disabled when Additional Printing is set to Do Not Apply. Default: 30.00 mm (1.181 inch) See the following when using single-ply film. U “Eye mark pitch (interval) when printing on single-ply films” on page 411 Eye Mark Sensor Position Sets the eye mark sensor position. U “Setting Eye Marks and Eye Mark Sensor” on page 125 Top (default) Select when eye marks are printed on the surface of the substrate. Bottom Select when eye marks are printed on the rear of the substrate.