L-6534VW Operation Guide Overview of the Product Feeding amount for the spliced section and margin When using the splice detection function, the feeding amount for the spliced section and margin (the value for b in the following figure) varies depending on the print speed. In addition, the feeding amount also varies when the set value of the tension applied to the substrate is small. * When the tension value for either one of unwinding or rewinding is 10 N or less 67 Sticking method Tape covers to the edges of the substrate 5 mm from the edge of the substrate is the splice detection area.
When including the shift in position of the splice, if 1.5 mm or more is covered in tape from the edge of the substrate to 5 mm from the edge, the splice can be detected. Sticking angle Within ± 30 degrees, perpendicular from the edge Thickness of the spliced section Total thickness of 0.2 mm or less at the point the tape overlaps or wrinkles. When printing over splices, the thickness should be 0.135 mm or less. Checked substrate color White, Black, Yellow, Light blue, Brownish Color, Clear, and Metallic Print Speed With normal tension With low tension* 50 m/min (Productivity) 14 m 26 m 30 m/min (Standard) 9 m 14 m 15 m/min (High density) 7 m 8 m 7.6 m/min (Reverse White) 7 m 7 m