L-6534VW Operation Guide Basic Operations Replacing the Substrate This section explains the procedure for replacing the substrate by splicing a new substrate to the previously loaded substrate. See the following for loading a completely new substrate without any previous substrate. U “Loading the Substrate from the Beginning” on page 371 Caution: ❏ When loading or removing roll substrate, be sure to secure appropriate personnel and appropriate transport equipment such as a lifter according to local laws on health and safety. You can install the roll substrate up to 100 kg (the diameter is up to ш600 mm).
Transporting, loading, or removing the roll substrate without following the instructions is extremely dangerous and could cause injuries such as trapping a hand or finger or dropping it on your foot. ❏ Be sure to adopt a sensible lifting posture whenever you lift the roll substrate. If you do not use the correct posture, an injury could occur. Note: ❏ See the following for more information on supported types of substrate. U “Substrate Specifications” on page 65 ❏ See the following when loading a new substrate after the previous substrate has been completely removed.
U “Loading the Substrate from the Beginning” on page 371 98 Contents Explanation Reference Replacing the unwinder side substrate Replace the substrate by splicing a new substrate to the previously loaded substrate. U “Replacing the Unwinder Side Substrate” on page 99 Replacing the rewinder side substrate Replace the substrate on the rewinder side with a new paper core. U “Replacing the Rewinder Side Substrate” on page 115 Setting the substrate on the touch panel After replacing the substrate on the rewinder side, set the substrate on the touch panel. U “Setting after Replacing the Substrate (Eye Mark for Reverse Feeding:
Do Not Use)” on page 124 U “Setting after Replacing the Substrate (Eye Mark for Reverse Feeding: Use)” on page 121